C-COM Satellite iNetVu Guide de dépannage télécharger pdf (Page 76)

iNetVu Troubleshooting Guide

C-COM Satellite Systems Inc.

Page 76 of 88

Step 4:

• Disconnect the coax cable going into the “RX” port on the base plate of the antenna.

• Measure voltage on this cable. If the voltage does not match the output of the controller,

replace the cable.

• If the voltage does match, reconnect the cable and proceed to Step 5.

Step 5:

• Disconnect the coax connecting to the LNB.

• Measure voltage on this cable. If the voltage does not match the 7000 Controllers output, it

concludes it’s an issue with the internal wire. Please contact C-COM Technical Support for

assistance.

• If the voltage does match, it concludes the LNB is the issue. Please replace the LNB and try

again.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 87 88

Pas de commentaire

C-COM Satellite iNetVu Guide de dépannage Page 76